In here I will try to explain the features of these rests.
- A: Live Rifle Guide Tension Adjuster. Used to set the tension of the rifle during recoil
- B: Live Rifle Guide Spring Cap. Used to gain access to the spring, just unscrew it and change springs. Also The return plunger assembly for the horizontal control has the same setup
- C: Dead Rifle Guide. Used to center the rifle in the rest. Loosen the retaining screw on top of the arm and slide the dead guide to position the rifle.
![]()
- D: Split Nut Adjusters. These are used to remove any play that might develop in the aiming controls.
- E: Rifle Leveler. This is used to level the rifle in the rest. Place the rest on a level surface level the support arm and then level the rifle barrel in the rest by loosening the two retaining screws and sliding the block up or down to bring the rifle barrel level. (Note: This is not intended for getting on target)
- F: Aiming Controls. These controls can be set for either a right handed shooter or a left handed shooter by removing the two screws that secure the control block and return spring block to the rest base. Switch sides with these two blocks to your preferred controlling side.
- G: Course Adjusters. These are used to get the rest level and on target. What I do is to first center the support arm in the rest both vertically and horizontally then I will get the scope centered on the middle of the target. Now i can take full advantage of the rests ample amount of travel.